When CAP default configuration is loaded, ether1 is considered a management port with DHCP client configured.
![default port for surgemail default port for surgemail](https://i.ytimg.com/vi/-ynXN2Bs4g0/maxresdefault.jpg)
This type of configuration is used when device need to be used as wireless client device controlled by CAPsMAN. When no specific configuration is found, IP address 192.168.88.1/24 is set on ether1, or combo1, or sfp1. All ethernet ports are added to switch group and default IP address 192.168.88.1/24 is set on master port. This configuration utilizes switch chip features to configure dumb switch. If device is connected to the network with enabled DHCP server, configured DHCP client configured on the bridge interface will get the IP address, that can be used to access the router.
DEFAULT PORT FOR SURGEMAIL MAC
Router can be accessed directly using MAC address. For CPE wireless interface is set in "station-bridge" mode, for AP "bridge" mode is used.Ĭonfiguration is the same as PTP Bridge in AP mode, except that wireless mode is set to ap_bridge for PTMP setups. There are two possible options - as CPE and as AP. Default IP address 192.168.88.1/24 is set on the bridge interface. In case of dual band routers, one wireless is configured as 5 GHz access point and other as 2.4 GHz access point.īridged ethernet with wireless interface. Other Ethernet ports and wireless interfaces are added to local LAN bridge with 192.168.88.1/24 address set and configured DHCP server. This type of configuration is applied to home access point routers to be used straight out of the box without additional configuration (except router passwords and wireless keys)įirst Ethernet is always configured as WAN port (protected by firewall, enabled DHCP client and disabled MAC connection/discovery).
![default port for surgemail default port for surgemail](https://media.windowscrush.com/2018/11/external-ip-address-300x143.jpg)
Wireless is configured as access point and bridged with all available Ethernet ports. IP address on WAN port is acquired automatically. LTE interface is considered a WAN port protected by firewall and MAC discovery/connection disabled. This configuration type is applied to routers that has both LTE and wireless interfaces. List of routers using this type of configuration: WAN port has configured DHCP client, is protected by IP firewall and MAC discovery/connection is disabled.
![default port for surgemail default port for surgemail](https://assets.rockpapershotgun.com/images/2020/08/Horizon-Zero-Dawn-PC-graphics-settings-Ultimate.jpg)
In this type of configurations router is configured as wireless client device. You can run command /system default-configuration print to see exact applied default configuration commands. There are several different configurations depending on board type: All RouterBOARDs from factory come with default configuration.